Commercial Toilet Tissue Dispensers
Commercial Toilet Tissue Dispensers
-
Surface Mtd, with Hood, Bright Polish, Double Roll Toilet Tissue Holder, 5126
Bradley Toilet Tissue Dispenser. Housing and hood made from bright polished stainless steel. Hinged hood prevents unintentional unraveling while keeping top ...
SKU: 5126-000000 -
Recessed, Bright Polish, With Hood, Double Roll Toilet Tissue Holder, 5123
Bradley toilet tissue dispenser. Recessed dispenser can accommodate two rolls of toilet tissue with standard cores. Will accommodate rolls up to 5 inches i...
SKU: 5123-000000 -
Vandal-Resistant Hood for Model 0264-1 - Toilet Tissue Holder 0264-1 NOT SUPPLIE
14 gauge satin finish stainless steel for use only with 0264-1 (specified and purchased separately).
SKU: 10-0267 -
Vandal-Resistant Hood for Model 0263-1 - Toilet Tissue Holder 0263-1 NOT SUPPLIE
14 gauge satin finish stainless steel for use only with 0263-1 (specified and purchased separately). 7 1/4" (184 mm) Wide
SKU: 10-0266
At least 2 products are needed to make a valid comparison.
You can compare up to 5 products.
Ready to price your restroom?
Build your layout online for an instant quote, or email us your plans. We ship nationwide and install with our own crews in Georgia, Florida, Alabama, Tennessee, South Carolina and North Carolina.
Commercial toilet tissue dispensers and holders
This collection holds more than 90 commercial toilet tissue dispensers and holders, also called toilet paper dispensers or bathroom tissue dispensers: single roll, double roll, multi-roll, jumbo roll, recessed, surface mounted, partition mounted and security models. We ship nationwide. In Georgia, Florida, Alabama, Tennessee, South Carolina and North Carolina, our own W2 crews can install them along with your toilet partitions and grab bars.
Which toilet tissue dispenser fits your restroom?
- Single and double roll holders: standard rolls, simple to service. Common in offices, clinics and small restrooms.
- Multi-roll dispensers: hold extra standard rolls in reserve so a stall is less likely to run out between cleanings.
- Jumbo roll dispensers: take 9 inch jumbo rolls for high traffic restrooms such as schools, arenas and travel stops.
- Recessed dispensers: set into the wall so less hardware sticks out into the stall.
- Partition mounted dual access: one unit mounts through the shared panel and serves two stalls. Some models combine a seat cover dispenser or a sanitary napkin disposal.
- Security and chase mount holders: for correctional facilities and high abuse areas.
- Matte black finishes: Fino and other matte black holders to match black partition hardware.
Where does a toilet tissue dispenser go in an ADA stall?
Section 604.7 of the 2010 ADA Standards for Accessible Design states: "Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser. The outlet of the dispenser shall be 15 inches (380 mm) minimum and 48 inches (1220 mm) maximum above the finish floor and shall not be located behind grab bars. Dispensers shall not be of a type that controls delivery or that does not allow continuous paper flow." Local codes can be stricter, so check the code your project is permitted under.
Order online or get it installed
Add dispensers to your cart and we ship them nationwide. For a full restroom, call 1-844-81-STALL and we will price the partitions, paper towel dispensers, hand dryers and accessories together, with installation in our six-state service area.